Run this by me again?
eth2 Link encap:Ethernet HWaddr 00:04:5A:80:BD:3A
inet addr:192.168.3.1 Bcast:192.168.3.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1842504 errors:39 dropped:0 overruns:0 frame:39
TX packets:0 errors:3651809 dropped:0 overruns:0 carrier:7167231
collisions:0 txqueuelen:1000
RX bytes:337022665 (321.4 MiB) TX bytes:0 (0.0 b)
Interrupt:12 Base address:0xb000
I really don’t think this is accurate, considering eth2 is the network interface where the WAP is hooked up. It works fine, obviously, since I’d never noticed anything wrong until I wanted to make some network usage stats (MRTG) for it.
Time to either upgrade the driver (kernel modules) or put a different network card in, then. *mutter*
No comments yet.